SCANNING FOR DAB STATIONS
With DAB radio, additional stations and services
regularly become available so it’s a good idea to carry
out a scan every now and then to make sure that you
have the most up to date station listing stored within
the memory of your radio. If you have moved your radio
to another location, e.g.: if you go on holiday, then it’s
also a good idea to carry out a scan.
1. If you are not already in DAB mode, press the
‘MODE’ button to go to DAB mode.
2. Press and hold the ‘MODE’ button for more than
1 second to begin a full scan for stations. The
display will change to ‘Auto Scan, Full Auto Scan’
and a progress bar will show the progress of the
scan and the number of stations found during the
scan will also be displayed. When the scan is
complete your radio will select the rst available
station and begin to play. The number of stations
found during the scan will be displayed. A station
scan takes approximately 1 minute but can take up
to 3 minutes.
NOTE: See page 5 for how to change DAB stations
after a scan.
STORING A DAB STATION PRESET
Your radio can store up to 10 DAB stations in its preset
memories for instant access to your favourites stations.
NOTE: When you store DAB radio station presets, these
do not overwrite your FM station presets.
1. Tune your radio to the station that you wish to
preset (see changing DAB stations, page 5).
2. Press the ‘PRESET’ button. ‘Preset 1’ is displayed
and ‘EMPTY’ if no previous station has been stored.
3. Use the ‘VOL +’ and ‘VOL ’ buttons to move to the
Preset location that you would like to store the radio
station to.
4. Press and hold the ‘PRESET’ button, the display will
conrm ‘Preset X stored’, where‘X’ is the number of
the preset (1-10).
NOTE: If there is already an existing DAB station
stored under a preset, it will be over written when
you store the new station.
TUNE TO A DAB PRESET STATION
In DAB mode:
1. Press the ‘PRESET’ button. ‘Preset 1’ is displayed
and the name or frequency of the station stored
there, or ‘EMPTY’ if no previous station has been
stored.
2. Use the ‘VOL +’ and ‘VOL ’ buttons to move to the
Preset location where the station you would like to
listen to is stored.
3. Press the ‘SELECT’ button. The radio will instantly
tune to that station and begin to play.
NOTE: If no DAB station has been stored under the
preset, the radio will immediately revert to the
previously selected radio station.
To Next Page
Loading...
