Technika DVD 105 - Playing a DVD Disc; Advanced Operation; Operating Functions; Handset Button Functions

To Next Page

To Previous Page

User HandbookDVD 105 DVD Player

Page 5

PLAYING A DVD DISC -BASIC OPERATION

Press OPEN/CLOSE to open the disc drawer

Load a disc into the tray, label side up

Press to close the disc drawer

The disc will now load. Some formats take more time to load than

others as the player has to read the disc, decide the format and

download the Table of Contents (TOC).

discs will display the ROOT or TITLE menu. In exceptional

cases where there is one title and nothing else the disc may play.

Press

Press to go forward one track at a time

Press to go back one track at a time

When you reach the final track you cannot go to the first track using

Press to go back through the tracks.

Press repeatedly

Speed increases 2X 4X 8X 16X

Press to resume normal play

Press repeatedly

Speed increases 2X 4X 8X 16X

Press to resume normal play

Press The disc will pause

Press to resume normal play

Repeatedly press

The film advances on frame at a time.

Press to resume normal play

Press

Speed cycles 1/2X 1/4X 1/8X 1/16X 1X

Press (or cycle to 1X)to resume

(In normal playback or Slow Motion)

Press repeatedly

The picture magnifies 2X 3X 4X 1X

Use the arrow keys to shift the zoom point

Recycle to 1X to restore normal zoom.

Press repeatedly to increase the volume

Press repeatedly to reduce the volume.

Press . The sound will be muted

Press again to restore the sound

The button on the DVD 105 has two modes.

When a disc is paused the may be stopped but the is

active. If the disc is paused for too long the surface may burn. A

special stop mode is available which stops the laser the disc

but memorises the position. When PLAY is next pressed the disc

picks up where it left off.

Press . The disc will stop

Press or to continue

play from the point at which STOP was

pressed.

Press STOP twice. The message ‘Press

PLAY Key to Continue’ disappears and

the disc is now stopped.

Press to play the disc from the start.

If you give the player an invalid command it will be

ignored and a ‘No Entry’ sign will flash on screen.

DVD

ENTER/PLAY

NEXT . PREVIOUS

ENTER

PAUSE/STEP.

ENTER

PAUSE/STEP.

ENTER

SLOW

ENTER

ZOOM

VOLUME +

VOLUME-

MUTE

STOP

ENTER RESUME

ENTER

To play an entire DVD disc from the beginning

2) To change tracks when a DVD disc is playing

3) Fast Forward Playback

4) Fast Reverse Playback

5) Pausing a disc

6) Frame Advance

7) Slow Motion

8) Zoom:

9) To alter the volume

10) To Mute the sound

11) Stopping the Disc

(In Pause/Frame Advance the sound is muted)

(In Slow Motion the sound is muted)

(not available at the digital audio outputs)

disc laser

and

Page 8

OPERATING FUNCTIONS

Below is a quick guide to all the handset key functions. The

symbol indicates that the function is available on the front panel.

Switch the mains power and ( )

Set the DVD 105 to ( )

Press to mute/unmute the audio output.

Clear a program. Clear an entry. Clear A-B repeat

Program play a disc in any sequence of your choice

Press to enter/leave the main DVD player setup menu.

Press to access the title menu on a DVD disc

Press to move through setup menus, etc.

Press to confirm a selection from a menu, etc

Fast forward search on a disc

Fast search in reverse on a disc

Press to resume playing when the disc has been paused.

Press to stop a disc while playing

Press to choose the language of a multi-language DVD soundtrack

Choose subtitles for a film (if the DVD disc supports this feature)

Select different camera angles (if the disc supports the feature)

Choose the PAL/NTSC video system. (UK system is PAL)

Slow motion playback of a video disc (6 speeds are available)

Open and close the disc tray.

Enter a number (See below)

Use to play a disc from selected tracks/time/chapter.

Confirm a selection

Change the size of the picture on screen

Press to move the disc successively back one track at a time

Press to move the disc successively forward one track at a time

Increase the sound (not operable on digital SPDIF outputs)

Reduce the sound (not operable on digital SPDIF outputs)

Repeat a track, repeat a chapter

Repeat a sequence between any two points of your choosing

Press once to pause a disc, press twice to stop the disc.

Play tracks in a random order

DVD players use and there are three principal kinds:

The player itself has a Menu which enables you to set up

the various parameters of the player.

The menu is the basic menu of a

DVD disc and contains all the information

relating to the DVD disc itself. This menu

loads when you first insert a disc. To

access this menu at other times, press

the MENU key

The shows the titles available on

the DVD disc. On many DVDs the ROOT

and TITLE menus are the same.

Each TITLE is further subdivided into

So by knowing the right command you can play the whole disc, or

any part of the disc as you choose.

The are mainly used

to navigate through Menus.

The key accesses the

DVD 105 player’s SETUP menu

and enables you to set up the

player - TV system, languages,

parental controls, etc.

The key accesses the DVD

disc’s TITLE menu.

Pressing or will take you to the menu list or return you to

the one.

Pressing or will take you or in the menu list.

Pressing confirms your selection.

Some functions require entries

from the NUMBER keypad.

To select a number between 0

and 9 just enter the number.

To select numbers from 10-19

(e.g. 11) press the key and

then the number (1).

To select a number between 20

and 29 press twice followed

by the number, and so on.

press the key to cancel the

entry

The key is used in combination with the number keypad to

go to a specific chapter or track or time on the disc from which to

commence play.

Press to access the root menu of the DVD disc

POWER

MUTE

CLEAR

PROGRAM

SETUP

TITLE

LEFT/RIGHT UP/DOWN

FORWARD

FAST REVERSE

RESUME

STOP

AUDIO

SUBTITLE

ANGLE

PAL/NTSC

SLOW

OPEN/CLOSE

NUMBER KEYPAD

GO TO

ENTER

ZOOM

VOLUME +

VOLUME -

REPEAT

A-B

PAUSE/STOP

SHUFFLE

ON OFF Front panel only

Standby Handset only

menus

SETUP

ROOT

TITLE

CHAPTERS.

Function Keys

SETUP

TITLE

ENTER

When you are in any menu the current choice is highlighted.

+10

If you make a mistake, CLEAR

GOTO

ENTER

FUNCTION KEYS AND MENUS

up down same

>>>>

TITLE 1

TITLE 2

LANGUAGE

CHAPTER

TITLE 1

of 2

of 5

CHAPTER

of 5

AUDIO

Press Play Key

To Continue

PLAYING A DVD -ADVANCED OPERATION

ON SCREEN DISPLAY

ROOT AND TITLE MENUS

CHECKING THE OPERATIONAL STATUS

An On Screen Display (OSD) disc status indicator will be displayed

at the top of the TV screen when certain functions are executed, or

when the button on the handset is pressed. When

different discs are loaded the indicators may change.

Load a DVD disc following the procedure above.

To display the menu: press . The root menu displays

the hierarchical structure of the DVD disc

To display the menu: Press . All the user choices

available on the disc are driven from this menu. The title menu

may contain one or several titles.

Press to display the TITLE menu

Navigate to the title

Press to play the chosen title.

The current highlighted choice should be actioned by the

key on the handset. You cannot action this choice from the

control on either the handset or the front panel.

The ON SCREEN DISPLAY can be configured to show the current

title playing, the chapter being played and various time modes.

Press continuously to cycle the display modes

DISPLAY

ROOT MENU

TITLE TITLE

DIRECT PLAY FROM THE TITLE MENU

TITLE

ENTER

PLAY/PAUSE

DISPLAY

Note:

TITLE 1

TITLE 2

TITLE 3

PLAY

ALL

TITLE 01/03 CH 02/06

Current Title

Total Titles

Current Chapter

Total Chapters

0:15:05

Total Time played on Disc

TITLE 01/03 CH 02/06

0:76:25

Total Time remaining on Disc

TITLE 01/03 CH 02/06

0:10:16

Time played on current chapter

TITLE 01/03 CH 02/06

0:07:06

Time remaining on current chapter

Display OFF

PRESS