Connection to the gas supply
For ease of service, the cooker should be connected with a
Flexible Hose, which complies with AS/NZS 1869 (AGA Approved),
10mm ID, class B or D, between 1 - 1.2m long and in accordance
with AS5601 for a high level connection.
WARNING: Ensure that the hose is not subjected to abrasion,
kinking or permanent deformation and should be able to be
inspected along its entire length. Unions compatible with the hose
fittings must be used and connections tested for gas leaks. The
fixed consumer piping outlet should be at approximately the same
height as the cooker connection point, pointing downwards and
approximately 200mm - 300mm in from the left hand side of the
cooker. The hose should be clear of the floor when the cooker is in
the installed position. The hose restraint chain supplied should be
anchored to the wall so that the chain prevents strain on the hose
connections when he cooker is pulled forward.
The supply connection point must be accessible with the appliance
installed. Fit the supplied elbow and gasket as shown in the
illustration below. The gas inlet connection has a 1/2" BSP male
thread. When making the connection, take care not to apply
excessive stress by counterbalancing tightening force. Ensure that
the available gas supply is the same as the gas type label affixed
near the gas connection point. If not, contact Technika for a Gas
Conversion Kit. The gas supply pressure must be adjusted in
accordance with the data label for the gas type. Adjust the test
point pressure with the largest burner operating at maximum.
Installation
A
B
C
A - Manifold Nut
B - Gasket
C - Elbow
32
To Next Page
Loading...
