Electrical connection
Fit a plug that is appropriately rated for the load indicated on the
data plate to the cable supplied with the appliance. The plug must
be compatible with the socket outlet fitted to the final sub-circuit in
the fixed wiring that is intended to supply this appliance.
If connecting the cable directly to the mains, install a suitable
isolating switch with a minimum contact opening of 3mm between
the appliance and the mains. The isolating switch should be sized
according to the load on the data label and should comply with
current regulations (the earth wire should not be interrupted by the
circuit breaker).
Connection to the electricity supply must be made by an
authorised person is accordance with the Wiring Rules
AS/NZS3000.
The supply cable should be positioned so that it does not reach a
temperature of more than 75℃.
Replacing the power supply lead
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
Before leaving
When the installation is complete, always check for gas leaks using
a soapy solution. Never use a flame to make this check.
Ignite all burners on high flame to ensure correct operation of gas
valves, burners and ignition. Turn gas taps to low flame position
and observe each burner to ensure they ignite completely at all
ports and that the flame is stable. Conduct these checks for each
burner individually and concurrently.
When satisfied with the hotplate, please instruct the user on the
correct method of operation. In case the appliance fails to operate
correctly after all checks have been carried out, please call the
Technika Service Centre.
Installation
33
To Next Page
Loading...
