TechniSat DIGIT ISIO S3 - Page 81

81
DE
EN
> If you do not want to select an option or wish to leave the Options selection
area without making any changes, simply press the Options buon until it is
hidden.
10 Initial installation
Aer you have read the safety instructions and connected the device as described in
Chapter 8 you can switch it on as described in Chapter 9.
On initial start-up of the device, theAutoInstallinstallation wizard starts
automatically. The installation wizard allows you to perform the most important
seings on your device.
Each step of the installation explains which seings can be savings.
> In the installation wizard start window, you can cancel the initial installation by
pressing the red function buon. The receiver then begins to run default pre-
programming.
In the subsequent installation steps you can press the OK buon to accept the
seing you have selected and move on to the next installation step.
By pressing the Back buon you can go back to the previous installation step.
This enables you to correct any incorrect entries at any time.
The initial installation shown here simply is an example.
The exact process for the initial installation will depend on the seings you select.
Therefore please follow all the instructions displayed on the screen.
Most of the seings in Autoinstall can also be changed at a later date via the
menu.