Why TechniSat DIGITRADIO 140 Tuner remote control not working?
If the TechniSat Tuner remote control isn't working, there might be a few reasons. First, check the batteries to ensure they are correctly inserted and not weak, replace them if needed. Second, make sure there are no obstructions between the remote and the device. Third, ensure you are within approximately 4 meters of the device.
How to fix no sound on TechniSat Tuner?
If you're not getting any sound from your TechniSat Tuner, try these steps: First, increase the volume. Second, make sure you've selected the correct source. Finally, check if the mute function is active and deactivate it.
How to fix TechniSat Tuner that will not turn on?
If your TechniSat Tuner won't switch on, ensure the mains plug is correctly connected to the power outlet. If it is, try using a different power outlet.
What to do if no DAB signal is being received on TechniSat DIGITRADIO 140?
If you're not receiving a DAB signal on your TechniSat Tuner, first check whether DAB reception is available in your region. Then, readjust the antenna and try to receive other stations. Finally, perform a station scan.
How to improve low or poor sound quality on TechniSat DIGITRADIO 140?
If the sound quality from your TechniSat Tuner is low or poor, try these solutions: First, move the unit further away from other devices like televisions that might be interfering with the reception. Second, extend the antenna and rotate it to improve reception.
How to stop interference on TechniSat Tuner?
If you're hearing interference on your TechniSat Tuner, it could be due to a mobile phone or another device emitting disruptive radio waves nearby. Try removing these devices from the unit's environment.
What to do if TechniSat DIGITRADIO 140 Tuner display does not switch on?
If the display on your TechniSat Tuner doesn't switch on, turn off the device, disconnect it from the mains, and then switch it back on.
Why no playback possible on TechniSat DIGITRADIO 140 Tuner?
If playback isn't working on your TechniSat Tuner, it could be due to a couple of reasons. First, ensure the device is in USB mode by switching to the appropriate source using the MODE button. Second, check that the medium is correctly inserted and contains music data.
What to do if CD is not playing or skips on TechniSat DIGITRADIO 140?
Here are some steps to troubleshoot CD playback issues on your TechniSat Tuner: * Ensure the CD compartment is closed properly. * Insert the CD correctly with the labelled side facing upwards and centered in the compartment. * Clean the CD or try another one. * If moisture is present, remove the CD and let the compartment dry for about an hour.
Why is the sound intermittent on TechniSat Tuner?
If the sound on your TechniSat Tuner is intermittent, it could be due to a few reasons. First, try decreasing the volume. Second, the CD might be damaged or dirty, so clean or replace it. Finally, the device might be exposed to vibrations, so install it in a location with low vibrations.
General| DAB+ | Yes |
|---|---|
| FM | Yes |
| Internet Radio | Yes |
| Bluetooth | Yes |
| WLAN | Yes |
| App control | Yes |
| Display | LCD |
| USB port | Yes |
| Headphone jack | Yes |
| Ethernet port | Yes |
| Frequency Range (FM) | 87.5 - 108 MHz |
| Frequency Range (DAB+) | 174 - 240 MHz |
| Battery | No |
| Type | DAB+/FM/Internet Radio |
To Next Page
