TechniSat DIGITRADIO 140 User Manual

30
8.2.5 Deleting a saved memory slot
> Simply save the new station in the respective channel slot as described in Section 8.2.3.
8.2.6 Signal intensity
> Press the INFO buon as oen as required until the signal intensity is shown:
Minimum signal intensity
Signal intensity
> The bar modulation shows the current level.
Stations with a signal intensity below the required minimum signal intensity are not transmiing a strong enough signal.
Adjust the antenna position again if required.
> Under the menu item Manual seing, you can select the reception channels individually and see their signal intensity.
You can adjust the telescopic antenna optimally for channels suering from poor reception in the installation location.
This is how stations which have not been found during a scan up until now can be found and played. To do so, select
MENU > Manual seing and then a station frequency. The signal intensity is thereupon shown in this frequency.
By pressing the INFO buon several times, dierent information is scrolled through, such as station type, multiplex name,
frequency, signal error rate, data bit rate, station format, date, DLS.
BDA DigitRadio 140.indd 30 16/04/2018 16:16

TechniSat DIGITRADIO 140 Specifications

General

Brand	TechniSat
Model	DIGITRADIO 140
Category	Tuner
Language	English