38
When the CD compartment is open, ensure that no foreign objects can penetrate the device. The lens of the laser sensor
must not be touched under any circumstances.
Only open the CD compartment when the CD has stopped.
Insert the CD carefully with the printed side facing upwards. Ensure that the CD is not positioned at an angle.
To insert/remove the CD, please hold it by the edge.
> Close the CD compartment using the ejector buon on the device (13) or on the remote control (1). The CD is read and
this is shown on the display (1).
Aer completing the reading process [Stop] appears on the display. With MP3 CDs, the album number also appears. If the CD
is inserted incorrectly or if the CD appears to be faulty, "No CD" appears on the display.
Do not perform any operation until the CD content has been completely read, to ensure that all the required information
on the CD has been read. With MP3 CDs in particular, this process can take some time.
> By pressing the Play/Pause buon on the remote control (2) you can start/pause the playback (the playing time flashes
on the display).
> The STOP buon on the remote control (16) stops the playback. The total number of tracks appears on the display.
Always stop the playback prior to removing the CD.
If there is no playback, the DIGITRADIO 140 switches to standby aer approx. 15 minutes.
12.2.1 Seing the track
> Folders/albums can be selected using the F- or F+ buons (25, 21) on the remote control.
> With the help of the Skip track forward/back buons (3, 15) on the remote control, it is possible to skip to the next or
previous track respectively.
The display shows the set track number (F = folder/album, T = track)
BDA DigitRadio 140.indd 38 16/04/2018 16:16
To Next Page
Loading...
Need help?
General
