Leaking baeries can cause damage to the remote control.
If the device is not being used for a prolonged period, remove the baeries from the remote control.
Important information for disposal: baeries can contain poisonous substances which harm the environment. Therefore,
it is imperative to dispose of the baeries according to the legal provisions in force. Never dispose of the baeries with
normal domestic waste.
3.3 Connection
> The audio outputs audio out analogue (18), optical out digital (20) or coaxial out digital (21) are available on the back
of the device to connect an A/V amplifier or a stereo system.
> Connect the rod antenna included in the supply to the antenna connection (23) and extend it to the desired length.
> Depending on whether you wish to use the LAN connection or the WLAN connection, connect the LAN cable for your
network to the LAN connection (22), or raise the WLAN antenna (17).
> Then insert the mains cable into a 110-240V ~ 50/60Hz mains outlet.
3.4 Switching on/o
> To switch on the DIGITRADIO 140, press the on/standby buon on the device (15) or on the remote control (14).
> To switch o, press the on/standby buon on the device (15) or on the remote control (14) again.
3.5 Source selection
> Press the MODE buon on the device (5) or on the remote control (8) repeatedly to scroll through the available sources.
Alternatively:
> Open the submenu in the current source by pressing the MENU buon and select >Main menu.
The source currently selected is shown on the display.
18
BDA DigitRadio 140.indd 18 16/04/2018 16:16
To Next Page
Loading...
Need help?
General
