43
EN
FR
IT
NL
NW
DK
PL
CZ
SK
13.2.3 Switching o/deactivating the alarm
> As described under 13.2.1, select the alarm memory (Alarm 1 or Alarm 2) you wish to switch o/deactivate.
> Open [Repeat] and set this to [O], to deactivate the alarm.
The alarm seings are not accepted until selecting [Save].
The alarm seings are retained so that this can be easily switched on/activated again at a later date.
13.2.4 Switching on/activating the alarm
> Select the alarm memory (Alarm 1 or Alarm 2) you wish to switch on/activate.
> Open [Repeat] and set this to Daily, Once, Weekend, or Working days to activate the alarm with the seings already
available (See Section 13.2.1).
If required you can adjust the other seings as described in Section 13.2.1.
The alarm seings are not accepted until selecting [Save].
13.3 Multi-room
In conjunction with the MyDigitRadio Pro app (available in the Apple App Store, Google Play store and AppStock), the
DIGITRADIO 140 oers multi-room support (for further information please see MyDigitRadio Pro app and on the website www.
technisat.de). With the MyDigitRadio Pro app, it is possible to remotely control multi-room enabled devices or to combine
groups on which the same music can then be played synchronously. If a device is switched ON/OFF from a group, all other
devices in the same groups are likewise switched ON/OFF.
The group set-up can also be undertaken in the Menu > Main menu > System seings > Multi-room.
Take into account that, for the multi-room mode to be unrestricted and smooth and operated via the MyDigitRadio Pro
app, this function must be switched on and the DIGITRADIO must remain connected to the network.
BDA DigitRadio 140.indd 43 16/04/2018 16:16
To Next Page
Loading...
Need help?
General
