SELECT to conrm and then your radio will connect the selected station.
Update Stations List
Simply press SCAN, or, press MENU, then press or to ‘Full scan’, press SELECT
to conrm.
To Show the Signal Strength
During playing a DAB/DAB+ program, repeatedly press INFO until the LCD screen
display shows a signal bar with the strength of the current station.
The indicator on the signal bar shows the
minimum acceptable signal level.
Note: Stations with signal strength below
the minimum signal level may not provide
a steady stream of audio.
Manual tune
Press 1. MENU press or to < Manual tune >, press SELECT to conrm.
Press 2. or to browse channels and press SELECT to select the current
channel.
Note: If there is a multiplex corresponding to this channel and frequency, the display
will show a tuning meter with the signal strength and the multiplex name after a few
seconds.
Press 3. SELECT again to exit this order.
The way to Prune
To remove all currently inactive stations, please follow:
Press 1. MENU press or to < Prune >, press SELECT to conrm.
Press 2. or to ‘Yes’, and then press SELECT to conrm.
DRC (Dynamic Range Control) value
You can set the compression level of stations to eliminate the differences in dynamic
range or sound level between radio stations.
Note: Set DRC to off indicates no compression;
Set DRC to low indicates little compression;
Set DRC to high shows maximum compression.
To Next Page
Loading...
General