TechniSat DIGITRADIO 380 CD IR

57
DE
EN
FR
NL
11.2 DAB radio reception
> Press the MODE buon as oen as required until [DAB Radio] appears on
the display.
Alternatively:
> Press the MENU buon and then select [Main Menu > DAB+].
If DAB is being started for the first time, a complete station scan is
performed. The station list is then shown (see Section 11.4).
11.3 Scanning
The automatic scan scans all DAB+ band III channels and thereby finds all stations
being broadcast within the reception area.
Aer the scan is complete, the first station is played back in alphanumeric
order.
> Press the SCAN buon (20) to carry out a full scan. “Scan” appears on the
display. The scan starts and a progress bar appears on the display.
> When this is complete, press the  or  buons and OK to select a station.
Alternatively:
> Press the MENU buon and use the  or  buons [Full Scan]. Confirm by
pressing OK.
If no stations are found, check the antenna and change the installation
location if necessary (Section 6.3.1).
11.3.1 Manual scan
Proceed as follows if you want to run a station scan manually:
> Select [Menu ] > [Set Manually] and press the OK buon.
> Use the  or  buons to select a station frequency and press the OK
buon.
If stations are being broadcast on the selected frequency, this will be
indicated on the stability bar (see also Section 11.8). If these stations are not
currently included in your station list, they will now be stored there.
11.4 Selecting the station
> You can check the stations found on the device. This is done by pressing the
buons  or .
> To select a station press OK.