The segments will count down in a loop pattern approximately as below :-
5. Try to countdown the set time in your mind. When you think the time is up, press SLEEP on the unit or the remote button. Try to
hit the set time as good as possible. Now the clock will display one of the results below, depending on when the button was
pressed.
6. After 10 minutes or by pressing by pressing SLEEP on the unit or remote button, the clock returns to normal time display.
Repeat by pressing SLEEP on the unit or remote button again.
TO ADJUST DISPLAY BRIGHTNESS
Press SNOOZE/ DIMMER repeatedly to select brightness of the display Bright => Low => Off => Bright.
This can only be done when the adapter is being used.
TO USE THE PROJECTION (operated by adaptor only)
1. Press PROJECTION once to turn on the projection.
2. Press PROJECTION once again to turn off the projection
3. When the projection is turned on, press and hold PROJECTION to flip the projected image upside down.
4. At the bottom of your unit, use the rotary knob to rotate the projected image by 90 degree.
Remark: when the clock is running the SLEEP function, the segment counting will be displayed and projected
at the same time.
REPLACING THE BATTERY OF THE REMOTE
Press down the latch on the remote, then open up the front and back case. Replace the lithium battery with a fresh one, make sure
the + polarity is facing up. Replace the front and back cases.
To Next Page
Loading...
