GB 4
time signal at 3:00, it will start reception at 4:00. If it fails again, it will start reception at 5:00. If it
fails again, it will start automatic reception at 1:00 again in the next day.
Manual reception: simply press and hold / WAVE, your clock will give a short beep and start
manual reception. Press and hold / WAVE to stop DCF reception.
During RCC reception, all buttons do not function and it does not take temperature measurement.
The temperature reading will get stable and become more accurate after your weather station clock is
powered up for around 30 minutes.
To cancel DCF reception permanently
Press and hold / WAVE and at the same time for 2 seconds, your clock will give 1 short beep
and the radio controlled function is permanently disabled.
To resume the radio controlled function, press and hold / WAVE and at the same time for 2
seconds, your clock will give 1 short beep and will start DCF immediately.
TO SET TIME
1. Press and hold SET, 00 flash, press / to set the time zone : -01,00,01.
2. Press SET again, hour digits flash. Press / to set the current hour. Press and hold
or to accelerate setting at high speed.
3. Press SET again, the minute digits flash. Press / to set minutes. Press and hold or
to accelerate setting at high speed.
4. Press SET again, display shows :05 and flash. Press / button to set snooze duration
from 5 to 60 minutes
5. Press SET to return to normal mode or it will return to normal mode in around 8 seconds if no
further press of any other buttons.
Your clock is in 24-hour display format.
TO SET ALARM (Default alarm setting is 6:00 AM)
1. Press and hold AL ON.OFF, the hour digits flash with “AL” icon appears. Press / to set
your desired alarm hours. Press and hold or to accelerate setting at high speed.
2. Press AL ON.OFF again, the minute digits flash. Press / to set your desired alarm
minutes. Press and hold or to accelerate setting at high speed.
3. Press AL ON.OFF again or if no further press of any other buttons in around 8 seconds to exit
alarm setting mode.
TO TURN ON OR OFF YOUR ALARM
Single press AL ON.OFF to turn on or off the alarm. When the alarm function is turned on, the AL
icon appears on top of the time digits.
TO USE SNOOZE ALARM (Default snooze duration is 5 minutes)
When time reaches your set alarm time, your clock will sound to wake you up. The AL icon will flash.
Press once to stop the alarm temporarily, AL icon keeps flashing. The alarm will beep
again in 5 minutes or after your set snooze duration.
TO STOP AND RESET THE ALARM TO COME ON THE NEXT DAY
To stop the daily alarm, press any button EXCEPT the when alarm is beeping. The alarm
will stop and AL icon becomes static; alarm will beep again same time next day.
To Next Page
Loading...
Need help?
General
