EN4
Part A - LCD
A1: Weather forecast pattern
A2: Time
A3: Radio Controlled Icon
A4: Time DST icon
A5: Weather station low battery indicator
A6: Indoor temperature and humidity
A7: Outdoor temperature and humidity
A8: Ice alert icon
Part B – Back buttons
B1: “MODE/SET” button
B2: “MEM” button
B3: “+/WAVE” button
B4: “-/CH” button
B5: battery door
Part C – TOP button
C1:“Light/snooze” touch button
Part D –Wireless Outdoor Sensor
D1: Battery door
D2: Channel switch
D3: TX button
Initial operation:
Open Weather Station battery compartment cover
Insert 2 x AA batteries observing polarity [ “+” and “ –“ marks]
When you insert the batteries, all icons on the LCD display will light up for 3 seconds,
you will hear a beep tone and the station detects indoor temperature & humidity.
The Weather Station will now start the outdoor remote sensor reception. This
operation takes about 3 minutes and is displayed by a flashing reception RF antenna
symbol in the “OUTDOOR” display area on the receiver.
Open Wireless Outdoor Sensor battery compartment cover, Insert 2 x AA batteries
observing polarity [ “+” and “–“ marks].
After receiver has a connection to the outdoor remote sensor after 3 minutes, it will
enter the radio controlled time signal reception mode.
Reception of the DCF signal:
The clock will automatically search the DCF (radio controlled time) signal after 3
minutes of any restart or changing of new fresh batteries. The radio mast icon starts
to flash.
At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization
procedure with the DCF signal to correct any deviations to the exact time. If the
synchronization attempt is unsuccessful (the radio mast icon disappears from the
display), the system will automatically attempt another synchronization at the next
full one hour. This procedure is repeated automatically up to total 5 times.
To start manual DCF signal reception, press and hold the “WAVE” button for two
seconds. If no signal is received within 7 minutes, then the DCF signal search stops
(the radio mast icon disappears) and will start again at the next full one hour.
During DCF reception to stop searching radio signal, press the “WAVE” button once.
Please note:
To Next Page
Loading...
Need help?
General
