Techno Line WS8007 User Manual

GB 2
Part B:
B1: “MODE” button
B2: “SNOOZE” button
B3: “ALARM” button
B4: “+/12/24” button
B5: “-/C/F/ ” button
B6: “RESET” button
Part C:
C1: Wall Mount Hole
C2: Battery Compartment
C3: Stand
3. Getting Started:
3.1 Main Unit:
 Slide open battery compartment cover [C2]
 Insert 4 x AA size batteries observing polarity [“+” and“ –“ marks].
 Replace battery compartment cover [C2]
 Use a pin to press the RESET [B6] button on the rear of unit, the unit is now ready for
use.
4. Time and Alarm Setting
4.1 Radio Controlled Clock:
 After batteries inserted, the clock automatically starts to scan the DCF time signal. Radio
Control Icon“ ” flashes on the LCD.
flashes,
Indicating now is receiving
DCF signal
turns on,
Indicating signal received
successfully
disappear,
Indicating signal reception
failed
 The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate
timing. If reception fail, scanning stops (“ ” on LCD disappear) and repeats again at
4.00 a.m. 5.00a.m. and6.00a.m.
 The clock can be set to scan the time signal manually by holding “ ” button (B5) for 3
seconds. Each reception takes about 5 minutes. If receptions fail, scanning stops. (“ ”
on LCD disappear) and repeats again on next full hour. E.g. scanning failed at 8:20a.m. It
will scan again at 9:00a.m.
 Stop scanning by holding “ ” button (B5) for 3 seconds.
 “DST” shown on the LCD if it is in Daylight Saving Time Mode
Note: Buttons will not function while scanning for DCF time signal unless they are well
received or stopped manually.

Techno Line WS8007 Specifications

General

Brand	Techno Line
Model	WS8007
Category	Clock
Language	English