EN 6
°C/°F temperature display:
The temperature is displayed either in °C or °F. Briefly pressing the “- “ button allows you to switch
between the individual models.
Reception of the Radio signal:
The clock automatically starts the DCF signal search on the batteries are changed. The radio mast
symbol starts to flash.
At 1:00am the Radio Controlled clock automatically carries out a synchronization procedure with the
DCF signal to correct any deviations to the exact time. If this synchronization attempt is
unsuccessful (The radio mast symbol disappears from the display), the system will automatically
attempt another synchronization at the next full hour. This procedure is repeated automatically up to
5 times.
To start manual DCF signal reception, press and hold the “-“ button, If no signal is received within
seven minutes, then the DCF signal search stops (the radio mast symbol disappears) and starts
again the next full hour.
To Next Page
Loading...
Need help?
General
