Techno HD Series User Manual

B
A
C
D
L1
L2 L3
Fig. 1.1
Enclosure
The Techno HD Series Router is powered by 220 Volt AC. Unless specially requested,
the electronics require 3-phase power.
The Electronics are housed in the large Nema
enclosure as shown in Figure 1.1. When unpacking
the machine avoid twisting the cable carrier that
guides the cables to the motors.
Have a suitably qualied
person connect the 220V
to the terminals. Make sure
that all local electrical codes
are obeyed. For single
phase machine, connect
power to L1 and L3 only.
1.1
1.4
I. TECHNO HD SETUP
Unpack the hand-
held controller
(shown in Fig 1.5)
and carefully
attach this to the
controller board.
(shown in Fig 1.6).
1.5
Fig. 1.5
Open the
back of the
enclosure
(shown in
Fig 1.2)
with the key
provided.
1.2
Fig. 1.2
Fig. 1.4 Fig. 1.7
1.7
If the machine has a vacuum
hold down pump, there is a
matching connector that will
plug into the controller box
(shown in Fig.1.7).
Guide the cable through the hole
on the side of the enclosure and
attach the hand-held controller to
the DB 15 terminal.
(shown in Fig. 1.6).
1.6
Fig. 1.6
The electronics will now be visible
and identiable and will be identical or
like depending on the model issued.
(shown in Fig. 1.3).
The terminals for the
220 volt connection is located at the
bottom of the box (shown in Fig.1.4).
1.3
Fig. 1.3
A -Controller Board
B -Stepper Driver
C -24 Volt PSU
D -220 Volt In
Vacuum Starter
Connection
HD SERIES Setup Instructions
HTT06031110
Tel: 516-328-3970
Email: support@technocnc.com
www.technocnc.com

Techno HD Series Specifications

General

Brand	Techno
Model	HD Series
Category	Control Systems
Language	English

Summary

Techno HD Series Router Setup

Electronics Enclosure Overview

Describes the Nema enclosure housing electronics and avoiding cable twisting during unpacking.

Opening the Enclosure

Instructions on opening the enclosure back with the provided key.

Electronics Identification

Explains that electronics are visible, identifiable, and similar across models.

220V Power Connection

Details connecting 220V power to terminals L1 and L3 for single-phase machines.

Hand-held Controller Connection

Guides routing the cable and connecting the hand-held controller to the DB 15 terminal.

Vacuum Hold Down Pump Connection

Describes the matching connector for the vacuum hold down pump.

Vacuum Pump Setup Guide

Vacuum Pump Rotation Warning

Critical warning about pump rotation direction to prevent vane damage.

Vacuum Hose Connection

Instructions on using the T-connector for vacuum hoses.

Vacuum Pump Control Box Wiring

Details on single and 3-phase control boxes and AC power connection for vacuum pumps.