Techno Premium Series User Manual

Techno
Inc.
HTT03170704
Premium Class Setup Instructions
Phone: 516-328-3970 · Web: www.technocnc.com
ADDITIONAL DOCUMENTATION
Can be found in the “More Manuals”
folder on your TECHNO CD-ROM.
INSTALLATION & SETUP TABLE OF CONTENTS
I. Machine Identifi cations
II. How To Use the Vacuum Table
III. Scale Factor Setup
APPENDICES
A. Techno Electronics
B. Colleting Guidelines
C. Machine Maintenance
CUSTOMER SUPPORT WEBSITE
http://support.technocnc.com/
Visit this site for software updates
and the Tech-Support Wizard.
This Wizard is password protected
for our customers.
Username: technocnc
Password: multiaxis

Techno Premium Series Specifications

General

Brand	Techno
Model	Premium Series
Category	Control Systems
Language	English

Summary

Machine Identifications

Incoming AC Power

Power Disconnect Switch

Airline Connection

Vacuum Table Operation

Vacuum Hold-Down Setup

Plug areas outside the workpiece, use gasketing, and operate vacuum valves for hold-down.

Scale Factor Interface Setup

Accessing System Settings

Inputting Scale Factor Values

Enter values from the machine's Scale Factor Sticker into the system interface.

Saving Scale Factor Changes

Appendix B: Colleting Guidelines

Proper Collet Assembly

Ensure collet is flush with the collet nut and snaps into place correctly.

Collet Installation Warning

Never push the collet into the spindle; only screw the proper assembly.

Balanced Tooling Requirement

Use balanced toolholders, collets, and tools to prevent spindle damage.

Appendix C: Lubrication Specifications

Lubrication Recommendations

Use specified Lithium-based or Urea-based grease and ISOVG32-68 sliding surface oil.

Y-Axis Lubrication (THK)

Premium Class Machine Maintenance

Lubrication Procedure

Apply specified grease to ball nuts and end bearings on X, Y, and Z axes.

THK Rails Lubrication