Techno
Inc.
HTT03170704
9
Premium Class Setup Instructions
Phone: 516-328-3970 · Web: www.technocnc.com
Continue to next page …
PREMIUM CLASS MACHINE MAINTENANCE
For regular work loads, machine maintenance is
required at least once a month. The machine should
also be lubricated once it is received.
Warning: Before inserting any object into the
machine, press the E-stop button.
Notes: Do not use WD-40 or silicon spray on
the machine. It may damage the drive
components of the machine.
Use the Grease and Oil recommendations
listed on the previous page, paying close
attention to what grease/oil must be
used!
I. LONG AXIS (Y) BALL SCREW:
1. Clean the ball screw with a dry rag removing old
grease and debris that may have collected.
2. Apply grease on the ball screw and run the
machine back and forth several times to spread
the grease out. By applying the grease and
running the axis back and forth, small particles
that may have collected in the ball nut may be
fl ushed out. It is recommended to repeat steps 1
and 2 again.
II. X-AXIS, Z-AXIS
BALL SCREWS AND END BEARINGS:
Notes: To access the X-Axis you must fi rst remove
the top panel covering it. This can be done by
unscrewing the screws on either side of the
axis and lifting the panel completely off of the
machine.
On the reverse side of the X-Axis are
the Ball Nuts, remember to apply grease to
those fi ttings!
1. Clean the ball screws with a dry rag, removing old
grease and debris that may have collected.
2. Apply grease to the the grease fi ttings on the ball
nuts and the grease fi ttings located on the end bear-
ings of the X-Axis and grease Z-Axis.
3. Run the machine back and forth along the axes
several times to spread the grease out and complete
the process.
LONG AXIS (Y)
X-AXIS BALL NUTS
(REAR VIEW)
END BEARINGS
(REAR VIEWS OF X-AXIS)
X-AXIS (FRONT VIEW)
Z-AXIS END BEARING
To Next Page
Loading...