16
For Support Visit· support.technocnc.com or Call: (631) 648-7481
HDS User Manual
(HTT06291133)
C-Pneumatic and Electrical Controls
The sections highlighted below are the buttons that control the pneumatic and
electrical outputs for the controller.
A
B
C
D
A - Shroud Down:
This button will raise or lower the dust shroud on the spindle.
B - Pins Up:
This button will raise or lower the pop-up pins on the sides of the table.
C - Vacuum 1 On:
This button will turn Vacuum 1 on, if it is connected.
D - Vacuum 2 On:
This button will turn Vacuum 2 on, if it is connected.
Shroud Down and Pins Up will only function if 90 lbs. of compressed air connected to the machine
Vacuum 1 and 2 send 220 volts to the starter coil of the vacuum pump, thus activating the pump.
To Next Page
Loading...