Technogym Selection Chest Incline - Adjusting the Cable Tension

19
Chest Incline
C
B
A
D
E
Adjusting the cable tension
To take up some of the slack in the weight stack cable proceed as follows:
- remove the front panel protecting the weight stack;
- use an Allen key (A) and an open spanner (B);
- loosen the nut (C) securing the screw (D) by half a turn in an anticlockwise direction;
- simultaneously turn both housings of the pulley, clockwise to tighten the cable
or anticlockwise to loosen it;
WARNING
Both housings must be turned the same distance on their respective
sides: to do this, constantly check that tabs (E) remain perfectly aligned.
- after completing the operation, tighten nut (C) to secure screw (D);
- refit the front panel protecting the weight stack.