Technogym Selection Chest Press - Page 20

20
A
Chest Press
Contents
Replacing the cable
- insert the new cable and retighten the
screws (A) of only one tension clamp
(follow the original path of the cable as
shown in the figure);
- insert a thickness of approx. 10 mm (1/2”)
under the first weight of the weight stack;
- bring the two levers into contact with the
rubber travel stops;
- tighten the cable and lock down the
screws (A) on the other tension clamp,
always keeping the levers in contact with
the rubber travel stops;
- remove 10 mm thickness (1/2”) from the
weight stack.
Identification of the manufacturer
and equipment
Description of the equipment
Technical data
Accessories
Assembling the number holder
Safety labels and devices
Packing
Place of installation
Unpacking
Lifting and handling the
equipment
Adjusting the equipment
Routine maintenance
Replacing the padded
components
Replacing the cable
Adjusting cable tension
Disassembling the front protective
weight stack panel
Technical Service
Codes for original spare parts
Storage
Disposing of the equipment
Using the equipment