~22~
Manual time set-up (the most important is to quit the reception of radio
controlled signal by holding together “+ “and“-” for 3 seconds in case of
the “radio tower”symbol flashing before set-up )
• Press and hold key “MODE“ for 3 seconds.
• The display for the year is flashing. Use “+ “ and “-“ to select the year.
• Press “MODE “ to confirm.
• The display for the month is flashing. Use “+ “ and “-“ to select the month.
• Press “MODE “ to confirm.
• The display for the date is flashing. Use “+ “ and “-“ to select the date.
• Press “MODE “ to confirm.
• The display for the time zone is flashing. Use “+ “and“-“ to select the time zone
(-12 to +12).
• Press “MODE “ to confirm.
• The language selection for the display of the weekdays is flashing. Use “+ “ and “- “ to select
the language. (GE = German, EN = English, IT = Italian, FR = French, DU = Dutch, SP =
Spanish, DA = Danish)
• Press “MODE “ to confirm.
• The 12/24 hour flashing. Use “+ “ and “- “ to select
• Press “MODE “ to confirm
• The display for the hour is flashing. Use “+ “ and “-“ to select the hour.
• Press “MODE “ to confirm.
• The display for the minutes is flashing. Use “+ “ and “-“ to select the minutes.
• Press “MODE “ to confirm.
• The country /city flashing. Use “+ “ and “-“ to select the city of Sunrise/Sunset and Moonrise
/Moonset. You can find a list of all cities and their abbreviations at the end of this manual.
• Press “MODE “ to confirm.
Information:
• While the Sunrise / sunset or the moon rise / sunset times be sought (Displaying dashes), the
station does not respond to keystrokes. Please wait for about 1 minute.
• The clock automatically changes from set-up mode to time display mode if no keys are
pressed for 20 seconds.
• Explanation for the time zone display:
You can manually adjust the clock to the time zone of a country (up to 1500km distance to
Frankfurt/Main) where the clock receives the DCF signal but where the actual time differs
from the time received.
If, e.g. the time in a given country is 1 hour ahead of the German time, set the time zone
display to 01. The clock is now DCF controlled but the time is one hour ahead.
Daily alarm set-up
• Press “MODE” to switch from time display to A1 display
• Press and hold the key “MODE” for 3 seconds ,the flashing alarm time is shown
• The hour display of the alarm time is flashing. Use “+“ and “-“ to select the hour.
• Press “MODE” to confirm.
• The minute display of the alarm time is flashing. Use “+“ and “-“ to select the minute.
• Press “MODE” to confirm.
• Then press “MODE” to switch from A1 display to A2 display
• The setting sequence for A2 is the same as for A1.
To Next Page
Loading...
