Technoline WS 6760 - Alarm Functions (On;Off and Snooze); Display Settings (Time Format & Units); Max;Min Data and Temperature Alerts

~23~
Daily alarm on/off
• Press “MODE” to switch from time display to A1 display
• When showing A1 alarm time, press “-“ to activate the alarm 1 with alarm symbol showing.
• Press “MODE” again cancel the alarm
• When showing A2 alarm time, press “-“ to activate the alarm 2 with alarm symbol showing.
• Press “MODE” again to cancel the alarm
• A1 for alarm from Monday to Friday, A2 for alarm from Saturday to Sunday.
Information:
• The clock automatically changes from set-up mode to time mode if no keys are pressed for
20 seconds.
• The alarm sounds for 2 minutes if no key is pressed to stop it.
Snooze function
To activate the snooze function, follow the steps below
• Press the key “SNOOZE/LIGHT“, while the alarm sounds, to activate the snooze function.
• If the snooze function is activated, alarm symbol is flashing.
• The alarm repeat after 5 minutes.
• The snooze function can be stopped by pressing any other key.
12/24 hours mode
• The time can be displayed in 12（AM/PM）or 24 hours mode. The switchover is described
in the section "Manual Settings".
°C/°F temperature display
• The temperature can be displayed in °C or °F. Press the key “-“ to switch between °C and
°F.
Max./ Min. for the indoor/outdoor temperature and humidity
• Press “+” for displaying of indoor/outdoor max./min. of temperature and humidity.
Temperature alert set-up
• Press “Channel” to select the channel (CH1, CH2, CH3) if more than one outdoor sensor is
used
• Press and hold the key “-” then select between ON/OFF.
• Press “MODE” , the upper limit temperature is flashing, use “+” , “-“ to set the maximum alert
temperature.
• Press “MODE “, the lower limit temperature is flashing, use “+” , “-“ to set the minimum alert
temperature.
• When the alert is activated, the alert symbol will be shown on the left of the outdoor
temperature display