GB 2
Alarm time mode
1. Alarm time
2. Alarm icon/Alarm on
3. Alarm mode indicator
GETTING STARTED
● Remove the battery door.
● Insert 4 new AA size batteries according to the “+/-” polarity mark on the battery
compartment.
● Replace the battery door.
● Once the batteries are inserted, full segment of the LCD will be shown before entering the
radio controlled time reception mode.
● The RC clock will automatically start scanning for the radio controlled time signal in 8
seconds.
Note: If no display appears on the LCD after inserting the batteries, press the [RESET]
button by using a metal wire. In some cases, you may not receive the signal immediately.
Due to the atmospheric disturbance, the best reception often occurs during nighttime.
DAYLIGHT SAVING TIME (DST)
The clock will automatically advance the time by one hour in the spring and back an hour in
the fall, provided that the DST function is not turned off. DST function is set to AUTO (On) by
default. The function can be disabled by manual settings.
RECEPTION OF RADIO CONTROLLED SIGNAL
This RC clock includes a built-in receiver which picks up the signal from the DCF station.
Therefore, the clock automatically sets the time, date and weekday.
● The clock automatically carries out four periodic synchronization procedures (at 2:00 AM,
8:00 AM, 2:00 PM and 8:00 PM daily) with the RC signal to correct any deviations to the
exact time.
● Once the unit synchronizes successfully to the RC signal, the signal icon “ ” will show
up. Each synchronization process will take between 6 to 16 minutes.
● To manually start or stop the RC signal reception, press [ RCC ] button.
Note: ● The strength of radio-controlled time signal from the transmitter tower may be
affected by geographical location or building around.
● Always place the unit away from interfering sources such as TV set, computer, etc.
● Avoid placing the unit on or next to metal plates.
To Next Page
Loading...
Need help?
General
