Technoline WS 9032 User Manual

21
IN key
OUT/+ key
ALM/DATE key
SET key
SNOOZE/CH key
DCF reception is done twice daily at 02:00 and 03:00 am. If the reception is not successful at
03:00 am, then the next reception takes place the next hour and so on until 06:00am, or until
the reception is successful. If the reception is not successful at 06:00 am, then the next
attempt will take place the next day at 02:00 am.
Once the outdoor data reception test period is completed, the DCF tower icon in the clock
display will start flashing in the upper left corner. This indicates that the clock has detected
that there is a radio signal present and is trying to receive it. When the time code is received,
the DCF tower becomes permanently lit and the time will be displayed.
If the tower icon flashes, but does not set the time or the DCF tower does not appear at all,
then please take note of the following:
• Recommended distance to any interfering sources like computer monitors or TV sets is
a minimum of 1.5 - 2 meters.
• Within ferro-concrete rooms (basements, superstructures), the received signal is
naturally weakened. In extreme cases, please place the unit close to a window and/ or
point its front or back towards the Frankfurt transmitter.
• During nighttime, the atmospheric disturbances are usually less severe and reception
is possible in most cases. A single daily reception is adequate to keep the accuracy
deviation below 1 second.
FUNCTION KEYS:
Weather Station:
The Weather Station has 5 easy to use function keys:
SET key
• Press and hold the key to enter manual setting modes: LCD contrast, time zone, time
reception ON/OFF, 12/24 hour display, manual time setting, calendar, temperature
°C/°F, pressure hPa/inHg, relative pressure value, and weather icon sensitivity setting
• Reset all MIN/MAX records
• Stop the alarm during alarm ringing
• Stop snooze mode
• Back-light on
ALM/DATE key
• Press and hold key for 3 seconds to enter the alarm setting mode
• Active/de-active the alarm time
• Stop the alarm during alarm ringing
• Stop snooze mode
• Display date
• Back-light on
IN key
• Press to toggle between MAX/MIN and current indoor temperature/humidity data
• Press to set the alarm hour (inside alarm setting mode)
• Decrease relative pressure value (within manual set mode)

Technoline WS 9032 Specifications

Temperature and Humidity

indoor temperature measuring range	-9.9ºC to +59.9ºC
indoor temperature resolution	0.1°C
outdoor temperature measuring range	-39.9ºC to +59.9ºC
outdoor temperature resolution	0.1°C
indoor humidity range	1% to 99%
indoor humidity resolution	1%
outdoor humidity range	1% to 99%
outdoor humidity resolution	1%

Data Checking Intervals

indoor temperature checking interval	Every 15 seconds
humidity checking interval	Every 20 seconds
air pressure checking interval	Every 15 seconds
outdoor temperature and humidity checking interval	Every 4 seconds

Transmission and Power

transmission range	up to 100 meters
weather station power consumption	3 x AA, IEC LR6, 1.5V
thermo-hygro transmitter power consumption	2 x AA, IEC LR6, 1.5V
battery life	up to 24 months

Dimensions

weather station dimensions	117.4 x 31.2 x 227.1mm
thermo-hygro transmitter dimensions	57.3 x 62 x 135.6 mm