SETTING UP:
1. First, insert the batteries in the transmitter (see “To install and replace
batteries in the temperature transmitter” below).
2. Within 2 minutes of powering up the transmitter, insert the batteries in the
temperature station (see “To install and replace batteries in the
temperature station” below). Once the batteries are in place, all segments
of the LCD will light up briefly. Following the indoor temperature the time as
0:00 will be displayed. If these information are not displayed on the LCD
after 60 seconds, remove the batteries and wait for at least 60 seconds
before reinserting them. Once the indoor data is displayed user may
proceed to the next step.
3. After the batteries are inserted, the temperature station will start receiving
data signal from the transmitter. The outdoor temperature data should then
be displayed on the Weather station. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset
from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the distance between
the temperature station and the transmitter should not be more than 100 meters
(see notes on “Positioning” and “868 MHz Reception”).
To Next Page
Loading...
Need help?
General
