EN 2
INSTALLATION
For best reception of radio controlled signal, keep your clock close to a window and away
from metal surfaces, electrical appliances and magnetic fields. Keep your clock at least 3
feet away from the AC outlet or the AC/DC adaptor. Plug the AC/DC adaptor to an AC
household outlet, then plug the DC jack to the back of the clock. Your clock is ready to
work for you.
BATTERY BACK-UP INSTALLATION
1. Slide open the battery cover at the back of your unit.
2. Insert the first AA battery into the right side of the battery
compartment and slide the battery to the left side. Then insert the second AA battery
into the right side again by observe the correct + / - polarity inside the battery
compartment.
3. Replace the battery cover.
4. When only batteries are being used, the always-on backlight is off.
DCF SIGNAL RECEPTION AND SIGNAL INDICATOR
After your clock is powered up, it starts to receive DCF signal. The icon flashes.
Weak or no DCF signal (only icon flashing)
Receiving strong DCF signal ( icon flashing)
Successful Reception ( icon becomes static)
Failed Reception ( icon disappear)
AUTOMATIC RECEPTION AND MANUAL RECEPTION
Your clock starts automatic reception everyday at 1:00, 2:00, 3:00. If it fails to receive the
DCF time signal at 3:00, it will start reception at 4:00. If it fails again it will start reception
at 5:00. If it fails again it will start automatic reception at 1:00 again in the next day.
Manual reception: Press and hold for 2 seconds button to start manual reception.
Press and hold button for 2 seconds to stop the reception.
Remark: when your clock is receiving radio controlled time signal, all buttons except the
snooze / light button do not function.
TO SET CALENDAR, 12/24 TIME AND TIME
1. Press and hold SET for 2 seconds, time digits change to “00”and flash. Press or
button to select time zone:
“00” = GMT +1 hour (e.g. Germany)
“01” = GMT +2 hours (e.g. Finland)
“-01” = GMT 00 hour (e.g. U.K.)
2. Then press SET once again, hour digits flash. Press or button to set hour. Press
and hold or will accelerate setting at high speed.
3. Then press SET once again, minute digits flash. Press or button to set minute.
Press and hold or will accelerate setting at high speed.
To Next Page
Loading...
Need help?
General
