TECLABEL DT2205 - Default Chapter; Table of Contents

i
Contents
1. Introduction ...........................................ii
1.1 Product Introduction ...............................................................................ii
1.2 Compliances ............................................................................................ii
2. Operations Overview .....................................1
2.1 Unpacking and Inspection ......................................................................1
2.2 Printer Overview ......................................................................................2
2.2.1 Front View ......................................................................................2
2.2.2 Interior View ...................................................................................3
2.2.3 Rear View........................................................................................4
3. Setup..................................................5
3.1 Setting Up the Printer..............................................................................5
3.2 Loading the Media ...................................................................................5
3.2.1 Loading the Media .........................................................................5
3.2.2 Loading External Media (For DT2205 model only)......................9
3.2.3 Loading Media in Peel-off Mode (Option) .................................. 11
3.2.4 Loading Media in Cutter Mode (Option).....................................13
3.3 Diagnostic Tool ......................................................................................15
3.3.1 Start the Diagnostic Tool.............................................................15
3.3.2 Printer Function (Calibrate sensor, Ethernet setup, RTC
setup………) ..........................................................................................16
3.4 Setting Ethernet by Diagnostic Utility (Option for DT2205 model)....17
3.4.1 Using USB interface to setup Ethernet interface......................17
3.4.2 Using Ethernet interface to setup Ethernet interface ...............18
3.5 Install MicroSD Memory Card ...............................................................20
3.6 Mount the Printer on the Wall ...............................................................21
3.7 Using the PC USB Keyboard with Printer USB Host Interface (Factory
option for DT039-50 model) ........................................................................22
4. LED and Button Functions ................................23
4.1 LED Indicator .........................................................................................23
4.2 Regular Button Function.......................................................................23
4.3 Power on Utilities...................................................................................23
4.3.1 Gap/Black Mark Sensor Calibration...........................................24
4.3.2 Gap/Black Mark Calibration, Self-test and Dump Mode ...........24
4.3.3 Printer Initialization......................................................................27
4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black