Tecma Nano ECO - User Manual

Questions and Answers

M
Mr. Scott GreenAug 4, 2025
How to fix Tecma Nano ECO Toilets when it does not flush?
- S
  scottsherriAug 4, 2025
  If your Tecma toilet isn't flushing well or at all, first empty the waste tank. A full tank can prevent proper flushing. Also, check for any clogs at the pump inlet and clear them, avoiding flushing foreign objects. A solid object in the macerator can also cause this issue; disable the power and carefully try to remove the object. Finally, ensure the toilet supply voltage is correct (12V+/-2V or 24V+/-2V) and that voltage drop during maceration is less than 10%, otherwise, there may be a wiring problem.
E
elizabethbeckAug 12, 2025
What to do if water does not enter bowl during flush in Tecma Nano ECO Toilets?
- J
  Joshua PattersonAug 12, 2025
  If water isn't entering the bowl during the flush or water add cycle of your Tecma toilet, check that the water supply line is properly connected and not kinked. Also, ensure the water pump is receiving power by checking the fuse/circuit breaker and electrical connections. Verify the main water supply is turned on. Lastly, if applicable, make sure the solenoid is correctly plugged into the relay module.
T
Tracey LeonardAug 19, 2025
Why does the bowl drain dry after flush in Tecma Toilets?
- T
  Thomas GonzalezSep 12, 2025
  If the bowl of your Tecma toilet drains dry after flushing, it's likely due to water siphoning out because the discharge hose is pulled down. Straighten the hose so that the top of the discharge hose is aligned with the toilet nozzle to resolve this issue.
J
james18Aug 27, 2025
Why does water continue dripping briefly into bowl after flush cycle is complete in Tecma Toilets?
- W
  whitethomasAug 27, 2025
  A small amount of water dripping from the nozzle of your Tecma toilet after the flush cycle is complete is normal operation.