PROVASET T3LPF REV.20210610
40
programmed
value, to measure the pressure on the component being tested.
Positive Delta max, maximum limit of increase of the actual test pressure compared
to the programmed nominal pressure
PN.
Programming range: such as PN.
Result MAX PRESSURE ERROR if the test pressure at the end of time is greater than
the maximum limit
PN +
Negative Delta max, maximum limit of decrease of the actual test pressure with re-
spect to the programmed nominal pressure
PN.
Programming range: such as PN.
Result MIN PRESSURE ERROR if the test pressure at the end of time is not greater
than the minimum limit
PN -
Field 0: Flow sensor full scale] l/min.
the programmed value
Flow rate at constant pressure -
trolled but only measured and depends on the regulated pressure
PN.
Field 0: [Flow sensor full scale] l/min.
Result
maximum limit FN + FD+.
Field 0: [Flow sensor full scale] l/min.
Result
is not greater than
the minimum limit
-
Flow rate at constant pressure
If programmed
= 0, the limit
the nominal test pressure
as well as the limit represents the minimum
: minimum and maximum pressure limits.
Represented By: GTEK AUTOMATION Lake Forest, CA 92630 Ph. 949-680-4242 www.gtek-automation.com
To Next Page
Loading...
