TECNA PROVASET T3LPF - Page 46

PROVASET T3LPF REV.20210610
46
5.6.4 Leak test: test parameters

T0

The test pressure is set to the programmed value

P0

PR_MAX .
With the option -V: range -800:
PR_MAX (mbar).
-
sure PR, however the programming of the parameter is free.


 / Pressure 
  = TIME) or when the test
pressure
PR  = PRESS.) is reached.

)
as soon as the
 test pressure is reached.


, to reach
the pressure
 in one or more steps.
Field 0: 255 steps ; 0=no ramp.


end part.
The parameter indicates the percentage of rising time for each step.
Dimension: 0: 100%.
Filling phase
T1
Filling time, range 0.0: 3600.0 s.

PR.
If  = 0, the test cycle starts directly from the settling phase  without opening the

external circuit before performing the test; the external circuit can be checked using
the delay function at Start (parameter
 ) and activating a programmable output
(parameter
PSOUT ).
PR
Nominal test pressure, range 0:
PR_MAX (mbar).
With the option -V: range -800:
PR_MAX (mbar).
Represented By: GTEK AUTOMATION Lake Forest, CA 92630 Ph. 949-680-4242 www.gtek-automation.com