PROVASET T3LPF REV.20210610
73
Then, by default, the menu page is displayed to export the updated database with
the new code to the pendrive, press the key on the message
to perform the export.
Pressing the NO key cancels the export procedure, the operator can perform this
operation at any time by pressing the
key.
If the operator presses the NO key on the message
, the operation is cancelled and the current PRODUCT or TEST PROGRAM will
be maintained.
The T3L database can contain a pre-established number of associations (e.g. codes),
once this number has been reached it is no longer possible to add associations and
an alarm message appears on the display indicating that the associations (e.g. codes)
in excess have not been loaded.
is only possible if carried out on a personal computer, therefore to carry this out it is
necessary to export the database from the T3L, modify it (with a PC) and subsequent-
To delete all the associations (e.g. codes) present in the database from the T3L, it is
-
er (columns with their names e.g. ).
three columns for inputting the following data: code, test cycle, notes.
: it must contain the codes of the components to be tested (barcode).
: it must contain the product number or program enabled for the test
cycle. To enable a product it is necessary to enter the desired product number,
to enable a program it is necessary to enter the letter P and the program num-
ber.
: this may contain useful descriptive notes for the user.
-
lon, comma or tab].
This setting is necessary to allow the correct reading of the CSV code database
: the operator can add associations (e.g. codes) to the T3L database by reading a
code using a barcode reader
NO: the operator cannot add associations (e.g. codes) to the T3L database.
The box shows the date and time of the last association (e.g. codes) import operation
in the T3L database.
Represented By: GTEK AUTOMATION Lake Forest, CA 92630 Ph. 949-680-4242 www.gtek-automation.com
To Next Page
Loading...
