The detergent dispenser is divided into four compartments;
1) Pour washing detergent in this compartment for the prewash cycle (MAX 45gr)
2) This compartment is for the wash cycle (MAX 130 gr powder detergent).
The liquid detergent tank (B) must be used for liquid detergent.
3) Pour bleaching liquid into this compartment following the advice on the packing (do ot
exceed in quantity over the filter grid).
4) Pour softener into this compartment following the advice on the packaging (max 60 ml -
do not exceed in quantity over the filter grid).
Close the dispenser after the detergent compartments have been filled. It is recommended
to use non-foaming detergents and a softener in case of hard water.
N.B.: Always follow guidance given by detergent manufactures for quantities required.
It is advisable to clean the compartment regularly, as explained below:
- press lever (A) ans slide the compartment out of its housing;
- remove the siphon cover of compartment 3-4;
- wash the compartments with running water;
- replace the siphon cover in the compartment making sure it fits perfectly in its housing;
- replace the compartment in its housing.
DETERGENT DISPENSER
CLEANING OF THE DISPENSER
INSTALLATION DIRECTIONS
ELECTRICAL CONNECTION
Make sure that the electrical system can support the maximum current as indicated on the
rating plate located on the rear side of the machine. The washing machine should be
connected to an electrical outlet with ground, as prescribed by law. This outlet must be
easily accessible after the, installation of the washing machine. If the supply cord is
damaged, it should be replaced by a special cable available at the manufacturers or at
the technical service. Therefore, the company will not be responsible for any damage to
persons or things due to non-compliance with these instructions.
PART B
To Next Page
Loading...