SORTING CLOTHES
Each of the following groups should be sorted and washed separately according to the cycle
specified in the cycle table :
- White and resistant coloured fabrics
- non-resistant coloured fabrics
- delicate fabrics (silk/rayon, nylon, etc.)
- wool
The washing/drying machine is designed to WASH only, to DRY only or to WASH +
DRY, for
instructions on how to dry clothes, read the “DRYING” section carefully.
WASHING OPERATIONS
- Sort the clothes
- place them uniformly inside the drum
- select the most suitable cycle for the fabrics (see wash cycle table)
- set the cycle by following the instructions in the “control panel” section and turn on
the
machine by pushing the ON/OFF button.
WARNING: Set the cycle only when the machine is off. - Always turn the control dial
clockwise. If you pass the desired position, make a complete turn and reset the dial to the
exact position.
WARNING.
It is important to remember, when the washing is finished, to push the on-off button, turn
off the taps and disconnect the plug.
CONTROLS PANEL
FUNCTIONS AND PREPARATION FOR WASHING
DRYING
The clothes are dried by a flow of warm air made to circulate inside the drum by a fan, which
gradually removes the damp from the clothes. This damp then condenses inside the machine
when it comes into contact with the cold water.
This is the reason why the water tap must remain on and the draining pipe must be
positioned correctly during the drying cycle.
To obtain the best results, spin-dry the clothes before putting them in the machine. The
smaller the amount of water in the clothes, the less time it will take to dry them and the lower
the consumption of electricity will be.
To Next Page
Loading...