T
ABLE OF QUALITY LEVEL IN ACCORDING TO DIRECTIVE UNI EN 13060 : 2009
CEN STANDARD UNI EN 13060 : 2009
Evaporation residue
≤
10 mg/l
Silicium oxide, SiO2
≤
1 mg/l
Iron
≤
0.2 mg/l
Cadmium
≤
0.005 mg/l
Lead
≤
0.05 mg/l
Rest of heavy metals except iron, cadmium, lead
≤
0.1 mg/l
Chloride (Cl’)
≤
2 mg/l
Phosphate (P20s)
≤
0.5 mg/l
Conductivity (at 20°C)
≤
15
µs/cm
PH value (degree of acidity) 5 to 7,5
Appearance Colourless clean without sediment
Hardness (E Ions of alkalin earth)
≤
0.02 mmol/l
9. EMPTYING THE WATER TANK
WARNING: SHUT DOWN THE AUTOCLAVE WITH THE MAIN BUTTON BEFORE
DISCHARGING THE TANK!
1. Connect the supplied pipe to the discharge tap 3A.
2. Unscrew the ring nut in counterclockwise direction Photo C (make 2 complete laps).
3. Wait that all the tank is emptied.
4. Rescrew the ring nut in clockwise direction Photo D.
5. In case of sterilisation failure, water in the tank could contain contaminated rests; used
protective lattice gloves to carry out this operation.
Photo C Photo D
To Next Page
Loading...
