TECNOEKA EKF 423 - Technical Service and Warnings; General Safety Warnings; Technical Specifications Overview

TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 4 __________________________________________________________________________________________
1. Technical service
A technical check-up once or twice a year helps prolong the life of the appliance and
guarantees better operation. Make sure that assistance is carried out solely and exclusively by
qualified personnel. For any spare parts orders or for any information about the appliance,
always mention the serial number and model (data indicated on the "technical data" plate at
the rear of the oven).
2. General warnings
Very important!: keep this instruction book together with the appliance for future consultation.
These warnings were drafted for your safety and for that of others. Please read them carefully
before installing or using the appliance:
- If, on receipt of the goods, the packaging is damaged, write the following on the delivery note:
“I REVERSE THE RIGHT TO CONTROL THE GOODS”, specify the damage and get the driver to
sign in acceptance; send a claim in writing to the seller within 4 calendar days from the date of
receipt. No claim shall be accepted after such period.
- The warehouse inside temperature must not be lower than -9°C; otherwise, the thermostat
(regulation and safety thermostat) control devices of the machine will be damaged. Failure to
observe this prohibition invalidates any responsibility of the manufacturer of the machine.
- The appliance is intended for professional use and must be utilised by qualified personnel
trained to use it.
- Any modification which may be necessary on the electrical system to enable installation of the
appliance, must be carried out solely by competent personnel.
- It is dangerous to modify or attempt to modify the characteristics of this appliance.
- Never clean the appliance with direct water jets, because, if any water enters, it could limit the
machine's safety .
- Before doing any maintenance or cleaning jobs, disconnect the appliance from the electrical
mains and allow it to cool.
- Do not attempt to carry out the periodic controls or any repairs by yourself. Contact the nearest
Service Centre and use only original spare parts.
- When the tilting door is wide open, do not put anything on the surface, because the door
hinges could be irreparably damaged.
N.B.: Improper or incorrect use and failure to observe the installation instructions shall release the manufacture
from all responsibility. In this connection, the directives in the "POSITIONING" paragraph must be strictly
observed.
3. Technical specifications
Appliance model
EKF 423
EKF 423 AL
EKF 423/001
EKF 423 U
EKF 423 M
EKF 423 M/3/100
Dimensions of appliance (mm) LxDxH
590x695x590
590x695x590
590x695x590
Weight of appliance (kg)
31
31
35
Maximum load per tray (kg)
1,5
Maximum load (kg)
6
Max absorted power (kW)
2,8
2,8
2,6
Convection heating element (kW)
2,7
2,7
2,5
Grill heating element (kW)
/
/
1,9
Top and bottom heater (kW)
/
/
2,3
Maximum load per pan (kg)
1,5
Power supply voltage (V~)
230 V~ (50/60 Hz)
Appliance class
I
Power cable diameter
3x1,5 mm²
Type of cable
H07RN-F
Electric cable connection
Type Y
The noise level of the appliance in operation is below 70 dB (A).
The "technical data" plate is positioned on the rear panel of the appliance.