Why are the control panel warning lights totally off on my TECNOEKA MKF 464 S?
If the control panel warning lights are totally off and your TECNOEKA Oven isn't working, it could be due to a few reasons. First, check the connection to the mains to ensure it's compliant. Second, verify that there is power supply voltage and restore it if necessary. Finally, the safety thermal device might have been triggered, so try to restore it.
What to do if the TECNOEKA MKF 464 S Oven humidifier is active but no steam is produced?
If the automatic humidifier is active but there's no humidity/steam production in the cooking chamber of your TECNOEKA Oven, start by checking the connection to the water mains to ensure it's compliant. Then, check the cock to make sure it's open. Also, inspect the water inlet filter for any obstructions and clean it if necessary.
What to do if TECNOEKA MKF 464 S doesn't work when the cooking cycle is set?
If your TECNOEKA Oven doesn't work when the cooking cycle is set, it might be because the door is not closed properly. Make sure the door is completely closed. If the problem persists, it could be due to a damaged door sensor, in which case you should contact a skilled technician.
Why does steam escape through the gasket on my TECNOEKA MKF 464 S Oven?
If steam escapes through the gasket of your TECNOEKA Oven when the door is closed, the gasket assembly might not be compliant. Check the gasket assembly. If the gasket is damaged or the handle “nose” is adjusted incorrectly, contact a skilled technician.
Why TECNOEKA Oven does not cook evenly?
If your TECNOEKA Oven isn't cooking evenly, it could be due to several reasons. One of the motors might be down or operating at a low speed, the motors might not be reversing direction, or a resistor might not be powered or is damaged. In all of these cases, contact a skilled technician.
How to fix the lamp in TECNOEKA MKF 464 S Oven?
If the lamp (LED) in the cooking chamber of your TECNOEKA Oven isn't working, it's likely that the lamp (LED) is damaged and needs to be replaced.
What to do if the thermal safety device is activated continuously in TECNOEKA Oven?
If the thermal safety device in your TECNOEKA Oven is continuously activated, it could be due to a damaged device or a damaged control thermostat. In both cases, contact a skilled technician.
General| Model | MKF 464 S |
|---|---|
| Category | Oven |
| Type | Electric |
| Power Type | Electric |
| Capacity | 4 trays |
| Number of Trays | 4 |
| Tray Size | 600 x 400 mm |
| Number of Cooking Levels | 4 |
| Heating System | Convection |
| Frequency | 50/60 Hz |
| Lighting | Yes |
| Color | Stainless Steel |
| Timer | 60 minutes |
| Door Glass | Double |
To Next Page
