TECNOEKA MKF 464 S - 1 Servizio Tecnico (Technical Service)

6
Only for wheeled models (MKF 1664 S – MKF 2011 S)
 After “pre-heating” the cooking chamber, it is necessary to act on the release device to actuate sliding
(upwards) of the internal door glass (position to insert the tray trolley). During this procedure,
appropriate heat protection clothing must be worn, burn hazard!
 Appropriate heat protection clothing must be worn when acting on the internal door glass after a
cooking cycle to slide it downwards (washing position/cooking chamber pre-heating), burn hazard!
 Appropriate heat protection clothing must be worn when extracting the tray trolley from the oven after
a cooking cycle, burn hazard!
 Ensure the tray trolley can be handled with ease, with no hindrance to insertion and extraction
operations: any collision may cause the spillage of hot liquids or food, burn hazard!
 Close trays containing liquids so these cannot be spilled when they are hot, burn hazard!
 When the tray trolley is inserted in the oven, before closing the door ensure the release device for sliding
the internal glass (door) has been activated and the glass is fully up: any impact of the trolley against the
glass might break it, injury hazard!
 The trolley is fitted with a suitable rod for locking trays. The rod must always be inserted when the
trolley is handled during use: trays might fall, injury hazard!
 If the tray trolley is not moved, the wheel parking brake must be engaged: the trolley might move on
uneven floors, injury hazard!
 While loading and unloading the tray trolley, engage the wheel parking brake: the trolley might move,
injury hazard!
 The tray trolley is mounted on wheels, therefore it might tip over if it is moved on uneven floors, injury
hazard!
 When inserting or extracting the tray trolley into or from the oven, pay the utmost attention not to
accidentally damage the internal glass gasket of the door: it is recommended to open the oven door
completely while moving the trolley.
1. SERVIZIO TECNICO (TECHNICAL SERVICE)
 It is essential for this instruction manual to be stored together with the appliance for future referencing;
in the event of misplacing it, a copy must be obtained directly from the manufacturer.
 This information has been prepared for your safety and that of others; therefore we kindly ask you to
read it carefully before installing and using the appliance.
 For periodic maintenance checks and repairs, contact your nearest Technical Support Centre and only
use original spare parts. Failure to comply with this provision shall forfeit the warranty right.
 All installation and commissioning operations must exclusively be performed by technically skilled
installers, in compliance with the instructions of the Manufacturer and in compliance with national
standards in force.
 The “technical data” plate is located on the side panel of the appliance.
Note: The inappropriate or incorrect use of the appliance and failure to comply with installation rules shall
invalidate any liability by the Manufacturer.