__ TECNOEKA Srl ____________________________________________________ operating and instruction manual _
_ page 22 _________________________________________________________________________________________
4.3.3.2 TEMPERATURE setting (PARAMETER SCREEN)
4.3.3.2 TEMPERATURE setting (PARAMETER SCREEN)4.3.3.2 TEMPERATURE setting (PARAMETER SCREEN)
4.3.3.2 TEMPERATURE setting (PARAMETER SCREEN)
Using the "STEP" key, you can set:
1. CAVITY TEMPERATURE
2. CORE TEMPERATURE
(The core probe is not included but is an optional accessory)
3. DELTA T value (
The core probe is not included but is an optional accessory)
1.
1.1.
1. CAVITY TEMPERATURE
CAVITY TEMPERATURECAVITY TEMPERATURE
CAVITY TEMPERATURE
Use keys and
to increase or decrease the temperature value (from 30°C to
260°C). Next, confirm your choice with the "SELECT"
"SELECT""SELECT"
"SELECT"
key.
With "COOKING IN PROGRESS": the value of the set temperature appears on the display
by the symbol, while the value of the actual temperature detected in the cooking
cavity appears by the
symbol.
2.
2.2.
2. CORE TEMPERATURE
CORE TEMPERATURECORE TEMPERATURE
CORE TEMPERATURE
Use keys and to increase or decrease the temperature value (from 0°C to 100°C).
Next, confirm your choice with the "SELECT"
"SELECT""SELECT"
"SELECT"
key.
With "COOKING IN PROGRESS": the value of the set temperature appears on the display
by the symbol, while the value of the actual temperature detected by the core
temperature probe appears by the
symbol.
When the CAVITY TEMPERATURE parameter and the CORE TEMPERATURE parameter
are given on the SUMMARY SCREEN, proceed as follows to go back to set the TIME
parameter :
-
Use the "STEP"
"STEP" "STEP"
"STEP" key to select the CORE TEMPERATURE parameter .
- Touch the "SELECT"
"SELECT""SELECT"
"SELECT" key (the PARAMETER SCREEN comes up on the display);
To Next Page
