TECNOEKA EKF 664 TC - Page 41

_ Electronic convection oven _ rev. 0 ________________________MODD. EKF 664 TC – EKF 711 TC – EKF 1064 TC
EKF 1111 TC – EKF 1664 TC – EKF 2011 TC
_________________________________________________________________________________________ page 41 _
ACTIVATING THE "HACCP" FUNCTION
ACTIVATING THE "HACCP" FUNCTIONACTIVATING THE "HACCP" FUNCTION
ACTIVATING THE "HACCP" FUNCTION
To activate the "HACCP" function, proceed as follows:
- insert the "USB drive" in the relevant "USB port" on the oven.
- set the cooking cycle (manual or programmed)
- touch the key to call up the "PROGRAMMING MENU" screen.
- keep tapping the "STEP"
"STEP""STEP"
"STEP" key until you select the "HACCP" option
- touch the "SELECT"
"SELECT""SELECT"
"SELECT" key to confirm your choice: the "HACCP" function is activated
Use the "START/STOP"
"START/STOP" "START/STOP"
"START/STOP" key to start the cooking cycle.
Once the cooking cycle has ended, the "HACCP" function switches off automatically.
VIEWING "HACCP" DATA (ON A PC)
VIEWING "HACCP" DATA (ON A PC)VIEWING "HACCP" DATA (ON A PC)
VIEWING "HACCP" DATA (ON A PC)
To view the parameters of a completed cooking cycle on a PC:
- hold your finger on the "START/STOP"
"START/STOP" "START/STOP"
"START/STOP" key for a few seconds and switch off the
oven
- remove the "USB drive" from the oven and insert it in the PC's "USB port"
- open the desired "file" contained on the "USB drive"
NB All data relating to cooking sessions performed on the same day are contained in the
same "HACCP" file.
Once another "HACCP" file has been created for a later day, the previous "HACCP" file
is renamed automatically, highlighting the date the cooking sessions took place.