TECNOMAGNETE ST200 Series

Need help?

Do you have a question about the TECNOMAGNETE ST200 Series and is the answer not in the manual?

Summary

Description of the System

Description of the controllers

Model ST100 X

Details the specifications, features, and components of the ST100X controller, including dimensions and power input.

Model ST200 X

Describes the ST200X controller's specifications, housing, grounding, protection, and power requirements, including dimensions.

Control push-buttons for ST controllers

ST100 (version with 2 levels), ST200 (version with 2 levels)

Describes the 2-level push-button panel for ST100 and ST200, allowing different magnetization levels.

ST200 (model with 7 levels)

Details the 7-level push-button panel for ST200, enabling multiple magnetization levels and providing status indications.

ST200 CH-ENABLE

Explains the CH-ENABLE push-button panel for ST200, allowing selection of discharge channels and magnetization modes.

Installation

General

Covers general electrical safety, grounding, protection switches, and power supply requirements for the controllers.

Connecting ST100 controllers to the power supply

Provides instructions for connecting ST100 controllers to a single-phase power supply, including cable specifications.

Connecting ST200 controllers to the power supply

Details connecting ST200 controllers to single-phase or three-phase power supplies, including cable and transformer recommendations.

PLC

Connection to the Tecnomagnete Module

Installation of miller ST100

Illustrates the connection of a magnetic module to the controller and power supply for miller applications.

Installation of grinder ST100

Shows the installation and connection of a magnetic module to the controller and power supply for grinder applications.

Installation of miller ST200

Provides connection diagrams for ST200 controllers with 1, 2, 3, and 4 chucks in miller applications.

Installation of grinder ST200

Shows connection diagrams for ST200 controllers with 1, 2, 3, and 4 chucks in grinder applications.

Ordinary Use

ST100

Step-by-step procedure for starting and operating the ST100 controller, including magnetization and demagnetization.

ST200

Procedure for starting and operating ST200 controllers, covering connection, switch operation, and magnetization/demagnetization.

Analysis of Residual Risks

Maintenance

Maintenance safety instructions

Provides critical safety instructions for maintenance operations, including PPE and disconnection from power.

Troubleshooting and Corrective Actions

Offers guidance for troubleshooting common problems and corrective actions for equipment issues.