HEATER INSTALLATION GUIDE
STEP 4
Plug in and turn on the chiller 1
Find the circuit board on the top of the electronic housing. 2
Remove the plastic “jumper” from prongs 4 and 5 (See
Diagram Below).
Place jumper on pins 7&8, this will reset your chiller. 3
Remove jumper from pins 7&8. 4
Now turn off your chiller. 5
CAUTION: Leaving chiller on with no water flowing will 6
cause the unit to overheat.
Place Jumper over pins 5&6 7
Note: Resting your chiller will change your set temperature 8
to the default of 77.
Re-connect the green ground cable, replace housing. Your 9
Chiller’s heater is now installed.
No Heater or UV
Heater and UV Installed
Heater Installed
UV Installed
Heater
Jumper
Reset
Jumper
UV
Jumper
To Previous Page
Loading...
