Need help?Do you have a question about the TECO SG2-12HR-D and is the answer not in the manual?
General| Coil Voltage | 12VDC |
|---|---|
| Ambient Temperature | -40°C to +70°C |
| Rated Voltage | 250VAC / 30VDC |
| Mounting | PCB |
| Release Time | 5ms max |
| Insulation Resistance | 1000MΩ (min.) at 500VDC |
| Dielectric Strength | 1500V AC for 1 min |
| Vibration Resistance | 10 to 55Hz, 1.5mm double amplitude |
A concise guide covering software installation, power connection, and basic communication setup.
Instructions for mounting the SG2 smart relay using DIN-rail or direct mounting methods.
Guidelines and diagrams for proper wiring of input/output terminals and power supply.
Overview of the SG2 Client software, its features, installation, and connection procedures.
Introduction to the Function Block Diagram (FBD) programming environment.
Overview of the SG2's built-in LCD display and keypad for operation and programming.
Introduces fundamental symbols like contacts, coils, and I/O points in RLL.
Details instructions for Set, Reset, and Pulse (Flip-Flop) output coils in RLL.
Explains Timer instructions, including 8 operation modes and configuration parameters.
Details Counter instructions with 9 operation modes, including up-down and high-speed counting.
Detailed explanation of PID controller instructions for process control.
General overview and operation rules for FBD function blocks.
Details on power supply requirements, voltage ratings, and consumption for different models.
Technical specifications for digital and analog input circuits.
Technical specifications for relay and transistor output circuits, including load handling.
Setting up RS485 communication parameters via software or keypad.
Guide to using the MU instruction for Modbus RTU master communication.
Instructions for configuring the SG2 to operate as a Modbus RTU slave.
To Next Page
