Need help?Do you have a question about the TECO SG2-20VR-D and is the answer not in the manual?
Procedures to follow after unpacking the SG2 smart relay.
Requirements for choosing an installation site for optimal functionality and lifespan.
A guide for connecting, programming, and operating the SG2 smart relay.
Instructions for installing the SG2 Client software.
Wiring diagrams for AC or DC power supply connection to the smart relay.
Steps to connect the programming cable between the SG2 and computer.
Procedure for establishing communication between SG2 Client software and the smart relay.
Steps to write and test a basic program using the SG2 Client software.
Instructions for DIN-rail mounting and direct mounting of the SG2 relay.
Guidelines and diagrams for wiring I/O signal cables, terminal torque, and wire sizes.
Features of the SG2 Client software for programming and testing.
Steps to install the SG2 Client software from CD or download.
Procedure for connecting the programming cable and establishing communication.
Introduction to the environment for programming using Ladder Logic.
Introduction to the environment for programming using Function Block Diagram (FBD).
Overview of basic symbols and their functions in Relay Ladder Logic.
Details on special elements like edge triggers and their functions.
Explanation of Set, Reset, and Pulse output instructions.
Details on Timer coils, operation modes, and parameters.
Information on Counter coils, operation modes, and parameters.
Details on comparator coils and their different comparison modes.
How to configure HMI instructions for displaying information on the LCD.
Instructions for configuring PWM output for specific models.
Details on Modbus RTU communication using MU instruction.
Configuration and usage of Analog Output (AQ) instructions.
Details on the AS function for addition and subtraction calculations.
Information on the MD function for multiplication and division.
Configuration and usage of PID control function.
How to use the MX function for multiplexing operations.
Details on the AR function for analog ramp control.
Information on Data Register (DR) function for data transmission.
Details on Timer function blocks, modes, and parameters.
Information on common counter function blocks, modes, and parameters.
Configuration and usage of PID controller function blocks.
To Next Page
General
