Chapter 3 Program Tools 25
Simulation Mode
The SG2 Client software includes a built-in simulator to test and debug programs easily without the need for
downloading to a controller. To activate simulation mode, simply press the RUN icon. The program below is shown
in simulation mode, identifying the significant available features.
Establish Communication
The following is the simple procedure for establishing communication between PC and the SG2 smart relay.
a. Select “O
peration/Link Com Port…” as shown below.
b. Select the correct Com Port number where the programming cable is connected to the computer then press the
“link” button.
c. The SG2 Client software will then begin to detect the connected smart relay to complete its connection.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
