Chapter 5 Relay Ladder Logic Programming        117 
-  
14BAQ (Analog Output) 
The AQ instructions must be used with extension analog out module, 2AO.The default output signal of AQ 
is 0~10V, the AQ value and the corresponding 12 bits data value are in the range of 0~1000 and 0~4095. It also 
can be assigned to output 0~20mA, in current mode; the AQ value and the corresponding 12 bits data value are 
within the range of 0~500 and 0~2047. The 12bits data saved in DRD4~DRD7. The output mode of AQ is set 
by the current value of DRD0~DRD3   
 
  Output register  Mode register 
Channel 1: AQ01  DRD4  DRD0 
Channel 2: AQ02  DRD5  DRD1 
Channel 3: AQ03  DRD6  DRD2 
Channel 4: AQ04  DRD7  DRD3 
 
Mode DRD0~DRD3 data definition 
1  0: voltage mode and reset value when stop; 
2  1: Current mode and reset value when stop; 
3  2: voltage mode and keep value when stop; 
4  3: Current mode and keep value when stop; 
※ Analog output works in mode 1 if the value of the mode register, DRD0~DRD3, is larger than 3. 
The appearance of AQ value on the HMI screen 
The HMI on SG2 displays the code of selected coil when SG2 at STOP mode, and showing the current 
value at RUN mode, see the below figure to get more information. 
 
 
STOP display          RUN display 
   
 
When AQ mode is in current mode, the relationship among the DR, 
AQ output and display value is shown as below: 
 
DRD5=2047, AQ02=500, display: 20.00mA 
 
 
※  When the preset value in “Analog Output Set” screen is a constant, this value will be stored in DR register, 
(DRD4~DRD7) and the AQ value equals to (DRx/4.095). For example, CH1 is configured as mode 1, set a 
constant value, 4000, then the value of AQ01 will be 977, and HMI displays 9.77V. 
※  Once the preset value refers to other variable, its value is also stored in DR register, (DRD4~DRD7), but it will 
be equal to AQx * 4.095. (DRx=AQx*4.095). 
※  More information about expansion analog input to see: Chapter 8 Expansion Module-Analog Module. 
Example 1: AQ01 preset value is a constant; the preset value of DRD4 refers to V01. 
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor