Chapter 3 Program Tools 41
Programming
The program can be edited by mouse, the following example describes the instructions for programming. Click
the right mouse button, selecting āConstants/Connectorsā on the appearing screen like below left one, or simply
click on the FBD the toolbar (see below right), then all available coil icons will come out.
Were selected symbol "M" and the "Q", the icon will be put to the editor area, and used to connect the two coils
connected as the left part of (Operation 1~3); if multiple cross-connections, they can use "scissors" functional
separation of the connection shown in the following figure the right part (operation 4);
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
