Need help?Do you have a question about the TECO SG2-20HR-D and is the answer not in the manual?
A brief guide for connecting, programming, and operating the new SG2 smart relay.
Wiring diagrams for connecting AC or DC power supply to the SG2 smart relay.
Procedures to open SG2 Client software and link to the SG2 smart relay via COM port.
Step-by-step guide to writing a basic program using M contact and Q coil in Ladder Logic.
Guidelines for I/O signal cable routing, terminal torque, and wiring diagrams for DC and AC power inputs.
Features and capabilities of the SG2 Client software for Ladder Logic and FBD programming.
Steps to connect the programming cable to the SG2 smart relay and computer.
Introduction to the SG2 Client's Ladder Logic environment, including model selection.
Overview of the SG2 Client's Function Block Diagram (FBD) programming environment.
Explanation of Set, Reset, and Pulse (Flip-Flop) output instructions and their behavior.
Comprehensive guide to SG2 Timer coils, operation modes, parameters, and configuration.
Detailed information on SG2 counter coils, operation modes, parameters, and compatibility.
How to use comparator coils to compare analog inputs, function values, or constants.
Configuration of Pulse Width Modulation (PWM) and Pulse Output (PLSY) for transistor output models.
Using MU function for Modbus RTU communication, including modes and parameters.
Configuration and usage of Analog Output (AQ) instructions with 2AO module for voltage or current output.
Configuration and operation of PID controllers for process control, including proportional, integral, and differential loops.
Usage of Timer Function Blocks in FBD mode, covering modes 0-7 and their parameters.
Explanation of Common Counter function blocks in FBD mode, including modes 0-6.
Implementing PID controllers using function blocks for process control in FBD.
Using the MU function block for Modbus RTU communication in FBD mode.
Using the MU instruction for Modbus RTU master communication, including modes and parameters.
Step-by-step guide to programming using the SG2 keypad in Ladder mode.
Step-by-step guide to programming using the SG2 keypad in Ladder FUNCTION BLOCK mode.
To Next Page
General
